![]() ![]() ![]() "Endpoint" is the IP or DNS with port number of the RouterOS device that the iOS device can communicate with over the Internet. The "Public key" value is the public key value that is generated on the WireGuard interface on RouterOS side. If allow-remote-requests is set to yes under IP/DNS section on the RouterOS side, you can specify the remote WireGuard IP address here.Ĭlick "Add peer" which reveals more parameters. This address will be used for communication. Specify an IP address in "Addresses" field that is in the same subnet as configured on the server side. The generated public key is necessary for peer's configuration on RouterOS side. Open it up and create a new configuration from scratch.įirst of all give your connection a "Name" and choose to generate a keypair. The command is the same for both routers:Īdd interface=wireguard1 list=LAN iOS configurationĭownload the WireGuard application from the App Store. Both remote offices need secure tunnels to local networks behind routers.įirst of all, WireGuard interfaces must be configured on both sites to allow automatic private and public key generation. Two remote office routers are connected to the internet and office workstations are behind NAT. The total amount of bytes transmitted to the peer.Īpplication examples Site to Site WireGuard tunnelĬonsider setup as illustrated below. The total amount of bytes received from the peer. Time in seconds after the last successful handshake. The most recent source IP port of correctly authenticated packets from the peer. The most recent source IP address of correctly authenticated packets from the peer. ![]() Will show already created Peer configuration and generate a QR code for easier peer setup on a client device. Specify when using WireGuard Server as a VPN gateway for peer traffic. It also can be generated if private-key is specified. Also can be generated automatically or entered manually, when the key is provided by the system administrator.Ĭan be generated automatically or entered manually, when the key is provided by the system administrator. This option adds an additional layer of symmetric-key cryptography to be mixed into the already existing public-key cryptography, for post-quantum resistance. Same as persistent-keepalive but from peer side.Ī base64 preshared key. For example, if the interface very rarely sends traffic, but it might at anytime receive traffic from a peer, and it is behind NAT, the interface might benefit from having a persistent keepalive interval of 25 seconds.Ĭlient-keepalive ( integer:0.65535 Default: 0) Persistent-keepalive ( integer:0.65535 Default: 0)Ī seconds interval, between 5 inclusive, of how often to send an authenticated empty packet to the peer for the purpose of keeping a stateful firewall or NAT mapping valid persistently. Name of the WireGuard interface the peer belongs to. The local port upon which this WireGuard tunnel will listen for incoming traffic from peers, and the port from which it will source outgoing packets. The IP address and port number of the WireGuard Server.Ĭlient-listen-port ( integer:0.65535 Default: ) The Endpoint port is the UDP port on which a WireGuard peer listens for incoming traffic.Ĭlient-endpoint (IP/IPv6 prefix Default: ) It is used by WireGuard to establish a secure connection between two peers.Įndpoint-port ( integer:0.65535 Default: ) The catch-all 0.0.0.0/0 may be specified for matching all IPv4 addresses, and ::/0 may be specified for matching all IPv6 addresses.Įndpoint-address (IP/Hostname Default: ) List of IP (v4 or v6) addresses with CIDR masks from which incoming traffic for this peer is allowed and to which outgoing traffic for this peer is directed. Allowed-address ( IP/IPv6 prefix Default: ) ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |